USB-Serial Update

Readme.md

@@ -69,6 +69,7 @@ Your Arduino IDE will output errors then if you double click the file and try to
 * Added USB Wakeup support
 * Separated USB-Core in its own folder
 * Added HID Tables
+* USB-Serial now fully reprogrammable
 ```
 
 ```

examples/Projects/USB-Serial/USB-Serial.ino

@@ -2,16 +2,21 @@
  Copyright (c) 2014 NicoHood
  See the readme for credit to other people.
 
- HoodLoader2 USB-Serial
+ USB-Serial
 
  Transferes from USB to HW Serial and vice versa.
  It also resets the main MCU on a DTR rise.
  */
 
+// define the reset pin to reset the destination MCU.
+// this definition is made for HoodLoader2 (pin 20)
+// but you still can use it with any other USB MCU or pin
+const int resetPin = MAIN_MCU_RESET_PIN;
+
 void setup() {
   // set main MCU by default active
-  pinMode(MAIN_MCU_RESET_PIN, OUTPUT);
-  digitalWrite(MAIN_MCU_RESET_PIN, HIGH);
+  pinMode(resetPin, OUTPUT);
+  digitalWrite(resetPin, HIGH);
 
   // Start USB and HW Serial
   Serial.begin(115200);
@@ -31,21 +36,28 @@ void loop() {
   if (Serial1.available()) {
     Serial.flush();
     // send maximum one EP_SIZE to give the usb some time to flush the buffer
-    uint8_t buff[USB_EP_SIZE-1];
+    uint8_t buff[USB_EP_SIZE - 1];
     int i = 0;
-    for (i = 0; i < USB_EP_SIZE-1; i++) {
+    for (i = 0; i < USB_EP_SIZE - 1; i++) {
       if (Serial1.available())
         buff[i] = Serial1.read();
       else break;
     }
     Serial.write(buff, i);
   }
-
-  // reset the main mcu if DTR goes HIGH
-  static bool lastDTR = 0;
-  bool newDTR = (Serial.lineState()&CDC_CONTROL_LINE_OUT_DTR) ? 1 : 0;
-  if (lastDTR ^ newDTR)
-    digitalWrite(MAIN_MCU_RESET_PIN, lastDTR);
-  lastDTR = newDTR;
 }
 
+void CDC_LineEncodingEvent(void)
+{
+  // start HW Serial with new baud rate
+  Serial1.end();
+  Serial1.begin(Serial.baud());
+}
+
+void CDC_LineStateEvent(void) {
+  // reset the main mcu if DTR goes HIGH
+  if (Serial.dtr())
+    digitalWrite(resetPin, LOW);
+  else
+    digitalWrite(resetPin, HIGH);
+}