 }})
+  }})
- Mr Beam is in a locked state as it does not know its position.
+ Mr Draw is in a locked state as it does not know its position.
First remove any objects blocking the gantry's travel range.
Then do a homing cycle.
@@ -657,12 +657,10 @@
- 1. Place your material on the working area -
- 2. Move the laser over the material -
- 3. Put on your safety glasses -
- 4. Turn the laser safety switch to on -
- → Now enable the focus mode -
- 5. Adjust the focus until the laser beam is as small as possible -
- → Disable the focus mode. +
- 2. Move the pen over the material +
- → Now enable the pen calibration mode +
- 5. Adjust the pen until it touches the paper +
- → Disable the pen calibration mode.