Any unknown commands should just be piped through and not use up an acknowledgement. This
new behaviour can be overridden via the new feature flag "unknownCommandsNeedAck", which will
restore the former behaviour causing even unknown commands to use up an "ok".
Also no line numbering or checksumming will happen. Shouldn't usually be of relevance for other
firmwares, but in case of any compatibility issues introduced by this also added a new feature
flag "sendChecksumWithNonGcode" that causes even unknown commands to be sent with a
checksum if necessary.
Repetier always first sends the ok and then any command output. In case of M105, that makes the response look like from an externally triggered heatup (no ok on the same line), causing polling to stop until that falsely detected heatup is complete. Added a configuration option to disable heatup detection. The disadvantage of this is that when printing via Repetier Firmware from SD, the heatup times won't be substractable from the total print time, leading to a less accurate print time left estimation.
Closes#835
* moved virtual printer into plugin
* made default serial factory use supplied parameters instead of directly utilizing self._port and similar
* documented new hook
2015-04-16 11:43:30 +02:00
Renamed from src/octoprint/util/virtual.py (Browse further)
