Cut off of the temperature graph is now not based on the number of data points any more but on the actual time of the data points. Anything older than ``n`` minutes will be cut off, with ``n`` defaulting to 30min. This value can be changed under "Temperatures" in the Settings
Closes#343
Sending "!!DEBUG:action_custom foo 1 2 3" will result in the virtual printer sending "// action:foo 1 2 3" back. Sending "!!DEBUG:action_custom bar" will result in the virtual printer sending "// action:bar" back.
If only one tool is configured, the profile dialog now won't show the offset configuration. If more than one extruder is configured offset configuration for anything but the first tool (which acts as reference for the relative offsets of the others) will be shown.
Closes#677
Instead of matching to full strings send by firmware in case of checksum or line number issues, now matches only against lower case "checksum", "line number" and "line expected". Should make it more resilient to firmware side changes of the sent messages.
jQuery bubbles all children show/hide events up to the parent so the
event gets called whenever a settings pane is chosen by the user.
Intent of the viewmodel callback was just on first show and final
dismiss.
Any unknown commands should just be piped through and not use up an acknowledgement. This
new behaviour can be overridden via the new feature flag "unknownCommandsNeedAck", which will
restore the former behaviour causing even unknown commands to use up an "ok".
Also no line numbering or checksumming will happen. Shouldn't usually be of relevance for other
firmwares, but in case of any compatibility issues introduced by this also added a new feature
flag "sendChecksumWithNonGcode" that causes even unknown commands to be sent with a
checksum if necessary.
Repetier always first sends the ok and then any command output. In case of M105, that makes the response look like from an externally triggered heatup (no ok on the same line), causing polling to stop until that falsely detected heatup is complete. Added a configuration option to disable heatup detection. The disadvantage of this is that when printing via Repetier Firmware from SD, the heatup times won't be substractable from the total print time, leading to a less accurate print time left estimation.
Closes#835
