31 lines
1.1 KiB
Text
31 lines
1.1 KiB
Text
(start of start.txt)
|
|
M92 E926.5 (the number of extruder steps to take in 1mm of filament)
|
|
G21 (metric values)
|
|
G21
|
|
G21 (all the extra G21 commands are comments - skeinforge eats lines without a gcode)
|
|
G21
|
|
G90 (absolute positioning)
|
|
G21
|
|
G28 X0 Y0 (move X/Y to min endstops)
|
|
G28 Z0 (move Z to min endstops)
|
|
G21
|
|
G21 ( if your prints start too high, try changing the Z0.0 below )
|
|
G21 ( to Z1.0 - the number after the Z is the actual, physical )
|
|
G21 ( height of the nozzle in mm. This can take some messing around )
|
|
G21 ( with to get just right... )
|
|
G21
|
|
G92 X0 Y0 Z0 E0 (reset software position to front/left/z=0.0)
|
|
G21
|
|
G1 Z15.0 F400 (move the platform down 15mm)
|
|
G92 E0 (zero the extruded length)
|
|
G21
|
|
G1 F75 E5 (extrude 5mm of feed stock)
|
|
G1 F75 E3.5 (reverse feed stock by 1.5mm)
|
|
G92 E0 (zero the extruded length again)
|
|
G21
|
|
M1 (Clean the nozzle then press YES to continue...)
|
|
G21
|
|
G1 X100 Y100 F3500 (go to the middle of the platform)
|
|
G1 Z0.0 F400 (back to Z=0 and start the print!)
|
|
(end of start.txt)
|
|
|