14 lines
1 KiB
Text
14 lines
1 KiB
Text
This is a firmware for RAMPS and other reprap single-processor electronics setups. It supports printing from SD card, active heatbed control, and ATmega internal pullups.
|
|
|
|
This work is licensed under the GNU GPL v3 or (at the user's discretion) any later version.
|
|
|
|
It is based on Tonokips's firmware, which was licensed under GPL v2 or later.
|
|
|
|
WARNING: The configuration file now has a value to set the wanted temperature table file. If you copy and paste a temperature file from older versions, make sure that the configuration is pointing to it. For example:
|
|
#include "ThermistorTable.h"
|
|
|
|
WARNING_2: In addition, you can optionally use a different thermistor table for hot-end and bed. To do so, comment the following line in configuration.h:
|
|
#define bedtemptable temptable
|
|
Then add a line pointing to your second thermistor table, for example:
|
|
#include "BedThermistorTable.h"
|
|
Finally, make sure that the nozzle thermistor table, inside ThermistorTable.h in this case, is defined as "temptable" and that the bed thermistor table is defined as "bedtemptable".
|